The Garrett Company
Hollywood Aluminum Wall Screen System

Part 1: General

1.1 Description of Work

A.  Work in this section includes furnishing and installation of Wall Screen System as manufactured by The Garrett Company
B.  Related Items and Considerations

1. Flashing of various designs may be required. Supplied by the installer.
2. Wall penetrations. Performed by qualified sub contractor.
3. Ensure adequate blocking to carry wall screen loads where required.
4. Any necessary removal or relocation of existing structures, obstructions or materials.

1.2 Quality Assurance

A.  Products meeting these specifications established standard of quality required as manufactured by The Garrett Company, Ball Ground, GA, 770-704-7140

1.3 Field Measurement

A.  Confirm dimensions prior to preparation of shop drawings when possible.
B.  If requested, supply manufacturer’s standard literature and specifications for shutters.
C.  Submit shop drawings showing structural component locations/positions, material dimensions and details of construction and assembly.

1.4 Performance Requirements

A.  Wall Screen must conform to local building codes.
B.  Determine if specific load requirements have been established for wall screen and if stamped calculations are required for location in which wall screen is installed.
C.  The wall screen must handle the minimum PSF live load for regional conditions.

1.5 Deliver, Storage, Handling

A.  Deliver and store all wall screen components in protected areas.

Part 2: Products

2.1 Manufacturer

A.  The Garrett Company
260 Valley St
Ball Ground, GA 30107
770-704-7140

2.2 Materials

A.  The product is the Hollywood Wall Screen System.
B.  Support frame to use .125” aluminum sheet.
C.  Screen to use slats 1” x 3” aluminum extrusions with a 2” space.
D.  Support frame to be 48” maximum spacing.

2.3 Finishes

A.  Standard finishes are powder coated with polyester resin.
B.  Optional finishes include standard 2-coat Kynar.

2.4 Fabrication

A.  All connections shall be mechanically assembled utilizing 3/16” fasteners with a minimum shear stress of 350 lb. Pre-welded or factory-welded connections are to follow ANSI Std Z49.1

Part 3: Execution

3.1 Inspection

A.  Confirm that surrounding area is ready for the wall screen installation.
B.  Installer shall confirm dimensions and elevations to be as shown on drawings provided by The Garrett Company.
C.  Erection shall be performed by an approved installer and scheduled after all concrete, masonry and walling in the area is completed

3.2 Installation

A.  Installation shall be in strict accordance with manufacturer’s shop drawings.  Particular attention should be given to protecting the finish during handling and erection.

3.3 After Installation

A.  Entire system shall be left in a clean condition.